Gain extra benefits by becoming a Supporting Member Click here find out how!

Classic Performance Products Classic Industries
American Auto Wire
Danchuk Catalog
Hellwig Products IncPerformance Rod & CustomNu-Relics Power Windows



Username Post: Powerglide ?
PLS 
"8th Year" Silver Supporting Member
Posts: 1567
PLS
Loc: Smyrna, Georgia
Reg: 06-07-12
02-06-19 11:16 AM - Post#2759203    
    In response to ragtp66

Ok checked the vacuum this morning and it seems to hold good. The new modulator was installed when the trans was rebuilt, but that doesn’t necessarily mean that it is good. I disconnected the tube from the modulator and pulled the other end off the carburetor and was able to blow thru good, everything has been cleaned up before reassembling the car and it looks like the rusty stuff in the rubber tube is only at the end and I can’t see any up in the metal line. I noticed when I remove the tube from the carburetor it pulled off really easy but when I pulled it off the metal line and modulator it took a bit of effort so I added a small clamp to make it tighter, not sure if that could have caused a problem but want know for a couple of weeks when I get it back out again. Once again thank you for your help and the link, Lamar
NOTE: You are viewing an individual Post. View the Entire Topic
FusionBB
FusionBB™ Version 2.1
©2003-2006 InteractivePHP, Inc.
Execution time: 0.196 seconds.   Total Queries: 13   Zlib Compression is on.
All times are (GMT -0800) Pacific. Current time is 12:57 AM
Top