Gain extra benefits by becoming a Supporting Member Click here find out how!

Classic Performance Products Nu-Relics Power Windows
American Auto Wire Hellwig Products IncPerformance Rod & Custom
Danchuk Catalog



Username Post: Help! - ssues with removing ignition lock
67SS427 
Ultra Senior Member
Posts: 12697
67SS427
Loc: Lawrenceville, GA, USA
Reg: 05-26-01
05-22-09 05:12 PM - Post#1702858    
    In response to wurt

Yes, as the others have said, you can't remove the lock cylinder without a key that works it. Only a working key can get the cylinder into the "locked" position, which is where it needs to go before you can turn it further using the paper clip. Also, if you have 2 holes, the paper clip only goes in the top hole. There is a way to remove it by drilling a hole in the face of the lock cylinder, after popping off the chrome cap. If you want to try that, I can give more info. Or, if you can drive your car, drive over to a locksmith and have him take it out for you and pop in the new cylinder.




NOTE: You are viewing an individual Post. View the Entire Topic
FusionBB
FusionBB™ Version 2.1
©2003-2006 InteractivePHP, Inc.
Execution time: 0.1 seconds.   Total Queries: 13   Zlib Compression is on.
All times are (GMT -0800) Pacific. Current time is 08:08 AM
Top